|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
fasr idle
hi all ..went to start bike after a few week let up and bike revs really high when cold and then idle dies away and i have to turn tickover screw right in to get an idle ...any ideas
|
#2
|
||||
|
||||
screwed air screw right in then out again and sorted must have been a bit of dirt
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
gas gas won't idle? read this! | ricardo cabeza | Enduro Intake/Carburetion - 2 stroke | 19 | 10-07-2013 01:33 PM |
can,t get idle up | geno | Enduro Intake/Carburetion - 2 stroke | 1 | 04-18-2010 08:49 PM |
EC 250 05 noo idle. settings?? | Laban1234 | Enduro Intake/Carburetion - 2 stroke | 5 | 07-21-2009 11:13 AM |
OK, how do I adjust the idle | thelonius | General Discussions & Announcements | 2 | 04-25-2009 07:41 PM |
Low Oil light at idle | floored | Enduro Engine 4 stroke (including EFI & Exhaust) | 3 | 10-02-2008 09:49 AM |