|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Any ideas on 2015 EC250 jetting?
I should be picking up a 2015 EC250 sometime soon, and just wanted to get a head start on on getting needles and jets ordered. If they are similar to the 2014's it sounds like feul consumption could be an issue, as I will be racing the bike. I'm not sure if the Keithin set up I ran on my previous orange bike would even be close, but I'd like to hear if it would even be a feasible starting place for the new Gasser, as it looks like a few riders on this forum have tried the NECJ Suzuki needles. This is what the previous set up was:
-NECJ 3rd clip -40 pilot -162 main -1.5 AS -7slide Most of the riding will be done between 500-1000ft, and mostly technical singletrack. 45-50 miles per tank at AA pace would be nice if possible.Thanks in advance for any advice! |
#2
|
||||
|
||||
That won't be a bad starting point, but probably will be lean off the bottom.
The 250's usually like a bit more fuel. The 2015 I setup here in Australia ended up with 42 NEDW#2 175 and runs pretty smooth and strong. |
#3
|
|||
|
|||
Right on. Thanks Jakobi! I will post up the ooutcome once I figure out what seems to work best.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
'09 EC250 Jetting - Baseline help? | liv2day | Enduro Intake/Carburetion - 2 stroke | 35 | 01-29-2016 08:00 AM |
98 ec250 carb and jetting | OKFiremanMark | Enduro Intake/Carburetion - 2 stroke | 5 | 07-22-2013 04:00 PM |
2005 EC250 Jetting | theexception_03 | Enduro Intake/Carburetion - 2 stroke | 25 | 08-24-2012 07:57 PM |
o3 ec250 jetting | dank | Enduro Intake/Carburetion - 2 stroke | 10 | 03-31-2010 01:17 PM |
Arizona: Jetting an '05 EC250 for 7K | AZRickD | Enduro Intake/Carburetion - 2 stroke | 13 | 08-18-2008 08:48 PM |