|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
2001 200 Timing Question
I Had remover stator searching for running problem, Could anyone out there help with the correct mark for timing, The bike was Dying out when it was warm, I have a coil tester and that was not it, also tried a different coil,
The bike will only run when cool, so just looking for any insight, also the stator area was dry, only looked like condensation. Thanks All
__________________
Shutup and Ride !!!!! |
#2
|
||||
|
||||
When you say dying out do you mean intermittant misfire then dies or just dies with no warning??
__________________
1998 EC250 07 Shivers 2T racing PV Spacer FMF Gnarly |
#3
|
||||
|
||||
it feels likes its running out of fuel, which its not, full tanks, starts and runs perfect when cold, Will run for approx 10 min, riding easy, when you ride race pace, 5 min tops and dies out. let sit 10 min. or so. will start and make it approx .5 miles and dies again
Not sure of the orig timing mark as it was set where you can see the bolt mark, not even close to the punch mark Thanks
__________________
Shutup and Ride !!!!! |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Timing a 450? | iancp5 | Enduro Engine 4 stroke (including EFI & Exhaust) | 4 | 05-28-2010 10:17 AM |
07 timing? | wence | Enduro Electrical & Wiring | 15 | 10-28-2009 03:42 AM |
2001 300 rear sprocket question | forgiven | Enduro Chassis & Body | 1 | 04-27-2009 04:48 PM |
Need HELP with timing | gasser | Enduro Engine - 2 stroke | 2 | 03-23-2009 02:17 AM |
450 Cam Timing question | Motarded1 | Enduro Engine 4 stroke (including EFI & Exhaust) | 4 | 04-09-2008 08:57 AM |