|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
11-12-2010, 07:41 PM
|
|||
|
|||
Inner and outer counter shaft seal
I have to replace these. this is the outer seal and the two o rings and bushing on the inner part. I have replaced the outer seal once and it was a pain in the arse to get it out. I can only wonder what the inner orings and bushing are like. Anyone done this?? any tips or tricks to know about. Should get into it next week sometime.
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Transnission shift shaft. | Trailrider | Enduro Engine - 2 stroke | 15 | 02-28-2010 05:10 PM |
| Outer diameter of Sachs fork at the triple clamps | Leon_gasgas | Enduro Chassis & Body | 3 | 01-20-2010 06:21 PM |
| Counter blance shaft issues | case-racing | Enduro Engine - 2 stroke | 7 | 12-20-2009 06:28 AM |
| Broken Kickstarter shaft | JCW | Enduro Engine - 2 stroke | 8 | 12-07-2007 08:31 AM |
| Counter shaft Sprocket Seal | Rick | Enduro Engine - 2 stroke | 4 | 12-03-2007 09:00 AM |
Threaded Mode