|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
THE US Source for Top-End Kits ?
Time for a top-end job.
Who is the best supplier nowadaze ? |
#2
|
||||
|
||||
Hall's Cycle. They have largest parts stock in U.S. Also centrally located in U.S. in Illinois (relative to shipping to either coast of U.S.). They have always invested heavily in their parts stock and have been a gasgas dealer for many, many years.
http://www.halls-cycles.com/ Alternatively - assuming you live in Arizona - your closest dealer would be moto city... http://www.azmotocity.com/ jeff
__________________
|
#3
|
|||
|
|||
And although I believe very firmly in supporting our dealers GasGas just uses Vertex Pistons so they are pretty easy to find
Sent from my iPad using Tapatalk |
#4
|
||||
|
||||
I have had great experience with Bob Piper at North Lake Tahoe Motorsports. I found him on ebay and have used him for OEM and aftermarket engine parts almost exclusively. Wossner pistons and all of the gaskets you would need. He takes requests, too, so you can ask for extra base gaskets, bearings, etc. He appears to have quite the stock, but I don't know if he is still a Gas Gas dealer since the restructure.
__________________
Phil (New bike pending...) |
#5
|
||||
|
||||
Quote:
__________________
2006 Gas Gas EC250 2011 Husaberg FE390 |
#6
|
||||
|
||||
Add me to the list, Bob is a straight up guy. Helped me out big time in the past.
Drove out of his way to deliver me a part that I needed while on a cross country trip to Idaho. Saved my ride for sure. Jeff Quote:
|
#7
|
|||
|
|||
__________________
-Keith '08 EC250 and some other bikes. |
#8
|
|||
|
|||
I told my dealer -- Moto City KTM/GG to go through Halls or North Lake Tahoe.
Vertex Pistons have done well for me. Actually, I haven't had problems with any make of piston I've placed in Gasser's. I tend to avoid forged Pistons, though. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Need to source a top end kit | Colemanian | Enduro Engine - 2 stroke | 3 | 05-03-2013 04:12 PM |
US Polisport source? | motorhead | Enduro Chassis & Body | 4 | 03-02-2013 08:50 AM |
Anyone have a source for the Big A$$ Syringes... | rgranger | General Discussions & Announcements | 16 | 02-28-2013 08:38 PM |
Source for top end gaskets? | jdosher | Enduro Engine - 2 stroke | 5 | 01-21-2013 08:37 AM |
Parts Source?? | rbm33 | General Discussions & Announcements | 25 | 02-28-2012 06:14 PM |