|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Power valve issue
Hi, My power valve assembly on my GasGas Ec 125 2006 is all right. Ive went over the manual multiple times and it is as it should.
When I attach the governer arm or what its called to the arm that actually raises the power valves, it gets stuck when I go to tighten it. If I tighten it a very tiny bit, it is hard to raise the valves. If I tighten it to a torque that feels legit to me so it doesnt vibrate loose, the power valve doesnt move at all. Im not able to raise the arm. Why is this, im confused? I popped of the cover when the gasser was on and when I give gas, it doesnt budge. This was in neutral gear however. Im not sure if they open in neutral but I suppose they do? Or is it different when ur actually in gear? Thanks a lot guys |
#2
|
||||
|
||||
In gear or not won't make any difference.
On the bigger bikes there is a bent piece of wire that moves vertical to raise the lever. It has a stepped bolt on the triangular plate that the valve attaches to. Is it the same arrangement? They use a nylock nut you have to burn plastic out or it can break this bolt then use a new one, available at hardware store.
__________________
'07 EC300 GG '14 TXT250 GG '? 496 CPI Cheetah RZ/RGV hybrid '22 765 Street Triple RS '21 XTrainer '69 Stinger T125 Suzuki '23 TRS 250RR (it's a Trials thing) |
#3
|
||||
|
||||
Get a new nylock nut and put it on but do not tighten it up against the actuator arm the nut will not move.
__________________
02 EC 200 03 MC 250 88 VT 800 01 TXT 280 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Old EC250 idle issue and power valve leaking... | 2ndGen | Enduro Intake/Carburetion - 2 stroke | 4 | 09-08-2021 09:49 PM |
Power Valve Adjustment issue | Dougie Dangerous | Enduro Engine - 2 stroke | 12 | 06-10-2020 02:26 PM |
2018 ec 300 power valve issue | Sterlo300 | Enduro Engine - 2 stroke | 8 | 10-27-2018 08:46 AM |
Ec300 rattle/power valve issue | Smithwoodwest | Enduro Engine - 2 stroke | 6 | 12-22-2016 07:46 PM |
ec125 -01 power valve issue? | Nicolas89 | Enduro Engine - 2 stroke | 83 | 08-06-2014 04:33 AM |