GasGas Riders Club Forum  

Go Back   GasGas Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.


Reply
 
Thread Tools Display Modes
  #1  
Old 09-08-2018, 04:36 PM
Thompo Thompo is offline
Member
 
Join Date: Aug 2017
Location: Northern Ireland
Posts: 77
Default Top end rebuild, lots of orings?

Hi folks,

Finishing off a top end on my mates 03 300.

In the gasket kit i have
base gaskets, powervalve cover gaskets, reed gaskets, exhaust Orings and gasket, water pump gaskets and head o rings.

There is also 7 other Orings.

Where do they go? I didn't remove any this size.

See pic attached

Cheers
Attached Images
File Type: jpg 15364424672111895252797848619774.jpg (126.3 KB, 23 views)


Reply With Quote


  #2  
Old 09-08-2018, 05:52 PM
Jakobi's Avatar
Jakobi Jakobi is offline
Super Moderator
 
Join Date: Oct 2010
Location: Australia
Posts: 7,573
Default

Looks a bit like a full gasket set..

2 x o-rings behind the counter shaft seal.
1 x o-ring on crank, clutch side.

Sometimes these kits are a bit generic and will throw in a few bits to cover variances across a couple years of a similar engine.
Reply With Quote
  #3  
Old 09-28-2018, 05:50 PM
BLD's Avatar
BLD BLD is offline
Member
 
Join Date: Sep 2017
Location: Northern CA USA
Posts: 39
Default

Two of those medium orings look like the two I just replaced with my countershaft seal and bushing.
__________________
I am done using apostrophes until I figure out why they all turn to question marks!
Reply With Quote
  #4  
Old 09-29-2018, 01:39 AM
(F5)'s Avatar
(F5) (F5) is offline
Gold Level Site Supporter
 
Join Date: Jul 2006
Location: Wellington New Zealand
Posts: 1,128
Default

Yeah what a screw up that is. Never seen a groove that needed 2 Owings pushing on each other.
__________________
'07 EC300
496 CPI Cheetah RZ/RGV hybrid
675 Street Triple R
RS125 framed MB100 racer
Stinger T125 Suzuki
Reply With Quote
Reply



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Cylinder orings Cox76y General Discussions & Announcements 2 05-13-2016 07:07 AM
Gnarly orings ec300 GregS Enduro Engine - 2 stroke 3 12-01-2014 07:15 PM
exhust springs and orings chinesegav United Kingdom 9 05-24-2013 06:51 AM
fork bleeder screws and orings flybars General Discussions & Announcements 9 09-10-2012 07:28 AM
Head orings Brian VT Enduro Engine - 2 stroke 5 09-05-2008 11:49 AM




All times are GMT -5. The time now is 02:37 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org