|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
08-26-2018, 12:34 PM
|
|||
|
|||
300 ec not running correct
I have a 2002 gas gas ec 300 its got good compression. It is very boggy in 1st and 2nd gear and the power band is hesatant to kick in. In 3rd 4th 5th an 6th its seems to be fine also if im off road it seems to run alot better than when im putting along on the road. Power band works alot better.
Any info on how to reslove this problem would be apricated 
|
|
#2
08-26-2018, 02:04 PM
|
||||
|
||||
|
Yes, head to the carb section and read up jetting suggestions. You will not believe the difference a needle will make. Until you do.
__________________
'07 EC300 GG '14 TXT250 GG '? 496 CPI Cheetah RZ/RGV hybrid '22 765 Street Triple RS '21 XTrainer '69 Stinger T125 Suzuki '23 TRS 250RR (it's a Trials thing)
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bike not running correct | Phaeton | Enduro Engine - 2 stroke | 3 | 10-06-2016 10:51 AM |
| correct seat ??? | gassergrant | Enduro Chassis & Body | 6 | 01-16-2014 01:32 PM |
| Correct warm up procedure | Chevva1 | Enduro Engine - 2 stroke | 4 | 06-09-2013 08:14 PM |
| this may not be the correct place to ask, but... | compmoto | SouthEast United States | 6 | 10-30-2010 02:10 PM |
| Correct plug? | Dunk | Enduro Electrical & Wiring | 5 | 07-24-2009 10:33 AM |
Linear Mode
