|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Loose frame nut...
Hi,
The M6 nut attached/pressed to the frame (sorry, don't know the right name for this kind of nut) where the upper pipe silentblock is fixed is loose (rotating on the frame), so it's not posible to torque it. Any idea on how to fix it ? kind regards, Marc
__________________
'05 GAS GAS EC 250 '15 KTM EXC 350 F '16 BMW R 1200 GS '83 Honda CB 400 |
#2
|
||||
|
||||
I presume this is a popnut. I guess the best fix would be to drill it out and insert a new one using proper tools.
__________________
Anders "So you know, that you're over the hill when your mind makes a promise that your body can't fill" (Little Feat: Old Folks Boogie) 2015 EC200 Racing: TE bars, Rekluse Core Exp 3.0, 38mm Lectron & Ohlins S3 steering damper 2006 EC200: 2011 plastics, Rekluse Z-Start, revalved KYB forks & Scotts steering damper 1998 Bimota Supermono 1986 Duc Mille S2 1975 Guzzi sidecar hack 1961 Morini Corsaro 125 etc |
#3
|
|||
|
|||
You might try flushing around the nut with solvent (lacquer thinners) and then running a bead of red loctite around the nut. Rotate the nut to get the loctite to creep in (maybe oscillate back and forth too). If the loctite sets OK the nut should be held in place. It's worth a try before drilling it out. The key is to get it really clean before adding loctite.
__________________
2011 EC250E |
#4
|
|||
|
|||
That's the problem, Anders, to find the "popnut" and the proper tools down here where I live....
__________________
'05 GAS GAS EC 250 '15 KTM EXC 350 F '16 BMW R 1200 GS '83 Honda CB 400 |
#5
|
||||
|
||||
could you get it Tig welded to the frame?
|
#6
|
||||
|
||||
No. The Riv nut is steel.
|
#7
|
||||
|
||||
__________________
Phil (New bike pending...) |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
loose front wheel | gump147 | Enduro Chassis & Body | 3 | 05-05-2015 12:40 PM |
Ferderer at the Loose Moose! | Rod Overstreet | Off Road Racer's Corner | 7 | 06-29-2014 11:23 PM |
Loose Airscrew | biggstr6 | Enduro Intake/Carburetion - 2 stroke | 6 | 07-29-2010 09:07 AM |
loose bottom marzocchi cap | noobi | Enduro Suspension | 2 | 06-06-2010 07:48 PM |
Loose yellow wire in airbox | stevethebrit | Enduro Electrical & Wiring | 2 | 09-30-2009 04:40 PM |