|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
If you have a stock bike you probably have a large squish measurement and you will pick up low and mid range power with little loss in top end if you use a thinner base gasket. If you have any ridge at the top of the cylinder you do not want to use a thinner base stack than what was in there previously because of possible ring snag at TDC.
While the factor stacks gaskets with few issues, I prefer the single gasket over a stack. Another option is to use some spray tack to glue together multiple gaskets. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Base gasket 2011 EC300 | Quigs | Enduro Engine - 2 stroke | 10 | 10-04-2015 04:58 PM |
wet base gasket | thejackrabbit | Enduro Engine - 2 stroke | 6 | 02-09-2014 01:03 PM |
Base Gasket re-use? | motogroove | Enduro Engine - 2 stroke | 5 | 06-26-2011 07:56 PM |
2010 300 Cylinder Base Gasket Question | coopernicus | Enduro Engine - 2 stroke | 12 | 06-22-2011 09:31 PM |
Base gasket | Ud_luz | Enduro Engine - 2 stroke | 21 | 05-09-2008 07:38 AM |