|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Clutch and brake lever cross over?
I have a couple of ASV levers here from my KTMs that i am going to see if i can use on my 06 EC300. It looks like the clutch is going to work, but i don't think the brake will (Brembo vs Nissin).
Anyone know a quick cross over from other models for these? I might have a CRF brake one somewhere, so i am assuming that might work. Cheers |
#2
|
|||
|
|||
I think the honda levers fit for the brake, but not sure.. They use the same nissin master I believe,,
|
#3
|
|||
|
|||
The front brake lever from a 01 CR250R fits.
The clutch lever from a GasGas trials MC fits. It is shorter than stock, which I prefer.
__________________
Eric K '06 GasGas EC300 '01 GasGas XC300 |
#4
|
||||
|
||||
does the clutch lever from an 01 CR250 fit as well or is it olny the brake
|
#5
|
||||
|
||||
Only the brake.
|
#6
|
|||
|
|||
Mine has a hydraulic clutch, so it might only be a KTM one that might fit. The Honda brake lever i have looks like it should fit, but i haven;t tried it yet.
|
#7
|
||||
|
||||
KTM(Magura) clutch lever is completely different and will not fit. Just GasGas(AJP master cyl.) levers.
|
#8
|
||||
|
||||
|
#9
|
||||
|
||||
Moose has the levers, any Parts unlimited dealer can get them.
__________________
Dont follow me, You wont make it. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rear brake lever GG 250 2009 | Klausen | Enduro Chassis & Body | 4 | 09-27-2010 04:46 AM |
Rekluse Clutch Brake Lever | kim | Enduro Engine - 2 stroke | 2 | 02-15-2008 07:41 PM |
Brake Pedal cross-over Part | Gas Stu | Enduro Chassis & Body | 0 | 09-03-2007 03:11 AM |
Front Brake Lever | cladoo | Enduro Chassis & Body | 4 | 02-07-2007 08:45 AM |