GasGas Riders Club Forum  

Go Back   GasGas Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.

Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 10-19-2011, 08:18 PM
lonetree lonetree is offline
Senior Member
Join Date: Feb 2011
Location: Victoria, Australia
Posts: 186
Default hole in engine?????

just dropped the gear oil on the ec250, a 09.....
inbetween the gear drain bolt and the crank drain bolt, i have found a drilled hole that appears to be tapped, approx 6mm but maybe a fine thread or somthing as a standard m6 wont quite go in....
WHAT is this hole? where does it go? should it have a bolt in it?
bike is running great, no oil leaking or anything, just dont want dirt and water getting into my engine.
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Similar Threads
Thread Thread Starter Forum Replies Last Post
Oil in the hole. boyscout General Discussions & Announcements 21 07-21-2011 03:08 PM
Small hole in bottom of engine ??? vgstef Enduro Engine - 2 stroke 1 01-17-2011 03:17 PM
Case hole? Neil E. Enduro Engine - 2 stroke 4 11-29-2010 10:16 AM
M6 hole under engine? moff747 Enduro Engine - 2 stroke 2 03-19-2008 10:48 PM
07 GG300EC - small hole at btm. of engine? g dirt Enduro Engine - 2 stroke 4 02-26-2008 05:48 AM

All times are GMT -5. The time now is 06:58 AM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
Copyright 2009 -