|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
A little help please
I have searched the internet and this site. The links for "manuals" that I have found from the "sticky" have the "parts breakdown" manuals.
Can anyone point me towards a "service manual" that a tech/shop would use for my '01 250xc. Anyone have an old one they want to sell? Or let me copy and send back? Can I use one for a later model such as a '07-'10? If I missed the link on this forum for one, please point me towards it. I just tore up my knee this past weekend and want to use the down time to rebuild the top and bottom end. I got smoked on a straight uphill by an '88 IT 200! Thanks for any help |
#2
|
||||
|
||||
I think most of this manual will work. The engines are slightly different, but fundamentally its pretty much the same stuff. I'm not sure if their is an earlier version.
This is on the last page of the sticky manuals thread in general discussion. http://www.gasgas.com/manuals/ec_shopmanual_06.pdf |
#3
|
||||
|
||||
Thanks Noobi!
|
Thread Tools | |
Display Modes | |
|
|