Rieju & GasGas Legacy Riders Club Forum  

Go Back   Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.


Reply
 
Thread Tools Display Modes
  #1  
Old 12-11-2014, 04:14 AM
spooly's Avatar
spooly spooly is offline
Senior Member
 
Join Date: Mar 2014
Posts: 308
Default First top end rebuild on 07 300..

Here's some pics and info, I would appreciate any comments or advice or if anyone spots something my untrained eye missed. . first of all I found two base gaskets I will be replacing with one what will the results be??
some pics of the old piston I think the new was overdue? ?
the cylinder looked good I could still see the crooshaching from the old hone.. I measured the ring gap at a couple of points down the cylinder with the new piston ring. . maximum ring gap was 0.20 the top of the cylinder ring gap was 0.15...
image of the head the carbon staining look odd all on the exhaust port side


Reply With Quote


Reply



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Rebuild bkwdc General Discussions & Announcements 5 08-01-2014 10:53 PM
Can I do a rebuild myself? stix49 Enduro Suspension 5 09-06-2012 12:39 PM
Top end rebuild... Woll Enduro Engine - 2 stroke 11 08-22-2011 07:24 PM
Need help on top end rebuild rpduc Enduro Engine - 2 stroke 17 03-26-2009 11:05 PM
05 rebuild brains Enduro Suspension 2 07-22-2008 08:54 AM




All times are GMT -5. The time now is 07:44 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org