|
|
|||||||
| Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
 |
|
|
Thread Tools | Display Modes |
|
#1
08-30-2009, 04:47 PM
|
||||
|
||||
wp 43mm fork oil height
just replaced seals in wp 43mm stock springs- i'm assuming 5w, somewhere between 110 and 140 air space/height - if anyone has a good height that worked for under 200lb rider, and was still plush - it would be appreciated. i can get clickers close i'm sure.
Last edited by stainlesscycle; 08-30-2009 at 05:38 PM. 
|
|
#3
09-01-2009, 05:26 AM
|
||||
|
||||
|
thanks - i put it at 120, 5w, no springs. it's not bad...gotta play with clickers a bit.
|
|
#4
07-13-2010, 12:52 PM
|
|||
|
|||
|
when measuring the oil height,this has to be done with the fork cap off and the outer tube completely down on the bottom tube?
like fully compressed ,with or without spring in the tubes? 5W oil in the forks too,right? thanks, hannes. ps: tried to search, but came up with too many topics to read 
|
|
#5
07-13-2010, 01:13 PM
|
||||
|
||||
|
cap off, springs removed, compress tube all the way down. 5w. 140mm is what ltr suggested. i'm at 135 right now.
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com 
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2001 ohlins fork oil height | on2wheels4ever | Enduro Suspension | 2 | 08-04-2010 06:35 PM |
| Oil height | wence | Enduro Suspension | 16 | 03-14-2009 04:08 PM |
| Fork oil height | skid jackson | Enduro Suspension | 1 | 08-22-2008 08:24 PM |
| Fork oil and height | JCW | Enduro Suspension | 5 | 11-24-2007 10:12 PM |
Linear Mode
