|
|
|||||||
| Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
|
Thread Tools | Display Modes |
|
#1
04-22-2012, 11:15 AM
|
|||
|
|||
2011 Engine / Frame alignment question
After 50 hours of riding I pulled my swingarm and linkage to check / grease the bearings. On reassembly, with all other engine mount bolts still tight, the rear engine "hole" doesn't line up well with the frame/swingarm/linkage (the engine sits about 1/16" low). Is this correct, ie is the frame / engine supposed to be connected with "tension", or should I relieve other frame bolt holes to remove it? Thanks for any advise.
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 05 engine in a 07 frame | PEB | General Discussions & Announcements | 3 | 10-18-2011 08:55 PM |
| airbox-reeds no longer in alignment. opinions/options please. | dank | Enduro Intake/Carburetion - 2 stroke | 10 | 07-26-2010 06:29 AM |
| An 01 GG 300 engine in an 04 GG 200 or 300 frame? | prentice | Enduro Engine - 2 stroke | 5 | 02-07-2008 12:07 PM |
| Engine mounts on to frame | west aussie gas 450 | Australia & New Zealand | 3 | 01-28-2007 08:16 PM |
| engine mounts on to frame | west aussie gas 450 | Enduro Engine 4 stroke (including EFI & Exhaust) | 1 | 10-26-2006 08:59 AM |
Threaded Mode