Rieju & GasGas Legacy Riders Club Forum  

Go Back   Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.


Reply
 
Thread Tools Display Modes
  #1  
Old 10-27-2006, 10:37 AM
justinmanus justinmanus is offline
Member
 
Join Date: Oct 2006
Posts: 4
Default 2000 Xc 250 wont start In mesa arizona

Ok here we go,
My bike will not start, here is the run down of what Ive done and any help you have to offer would be needed.
1 kick it over for a million times
2 drain all gas and put fresh pre mix in it
3 changed plugs
4 held new plug outside against head to look for spark,( no spark )
Backround
A week ago road it for 20 mins on this little trail close to my house
Was puting on the trailer and a strap broke bike fell over on the right side. I went to go riding this week no start. The kickstarter feels a little different but that could be me, looked for loose wires dont see any. Could the coil have gone bad, could the kill switch be acting up, has a stator ever been knocked loose, where to start any help.(Oh ya going to gordens well in 2 weeks gotta have the gas gas)
Thanks
Justin



Last edited by justinmanus; 10-27-2006 at 10:39 AM. Reason: typo's
Reply With Quote


  #2  
Old 10-27-2006, 10:59 AM
GMP's Avatar
GMP GMP is offline
Senior Member
 
Join Date: Jul 2006
Location: Jefferson Twp., NJ
Posts: 7,597
Default

First disconnect the kill switch and try it.

Next go through all your electrical connections, starting at the coil being it fell on that side (could it have hit the coil??). I crashed hard enough this summer to break the brake fluid resevoir off the frame with my knee brace, so a damged coil/wire is possible.

Check the HV wire connection to the coil and plug cap. There is a screw that just threads into the wire on each end. Sometimes this comes loose. You can cut a few mm off each side and thread the wire into the coil and the cap back on the wire. Use a little silicone RTV to seal it.
Reply With Quote
  #3  
Old 10-27-2006, 12:24 PM
justinmanus justinmanus is offline
Member
 
Join Date: Oct 2006
Posts: 4
Default 2000 Xc 250 wont start In mesa arizona

It may have hit the coil not sure no visable damage, I will check all the wires leading into the coil again just to confirm when i get off work.
Thanks
justin
Reply With Quote
  #4  
Old 10-27-2006, 05:27 PM
Brian VT Brian VT is offline
Senior Member
 
Join Date: Jul 2006
Location: Vermont, USA
Posts: 827
Default

"2000 Xc 250 wont start In mesa arizona"

Will it start in Tempe ? (lol. sorry.)
Reply With Quote
  #5  
Old 10-30-2006, 10:07 AM
gtsnowcrack gtsnowcrack is offline
Member
 
Join Date: Jul 2006
Location: Mesa, AZ
Posts: 39
Default

Hey I live in Mesa too, I haven't see you out on any of the trails though. I'm on a yellow EC200, do lots of riding at Sycamore.

As for no spark with the plug, did you do this in a a lit area? Sometimes it can be really tough to see the spark if you're not in the dark.

That's all I've got.
Reply With Quote
  #6  
Old 10-30-2006, 05:52 PM
TeeJay TeeJay is offline
Member
 
Join Date: Oct 2006
Location: South Wales
Posts: 42
Default

Have you tried starting it in any other states ?













Sorry, I couldn't resist
Reply With Quote
  #7  
Old 11-01-2006, 04:32 PM
justinmanus justinmanus is offline
Member
 
Join Date: Oct 2006
Posts: 4
Default

yes ive tried it in all the closed city's and it still wont start. I bought a new coil today but will not be here for a couple days.
I ride sycamore sometimes and P&D in scottsdale
Thanks for all the support next I will try a different state if that dont work
Justin
Reply With Quote
  #8  
Old 11-02-2006, 06:05 AM
rockyroad rockyroad is offline
Member
 
Join Date: Jul 2006
Posts: 27
Default

As GMP said, Don't overlook kill switch. Take it off the bars and try......been there.
Reply With Quote
  #9  
Old 11-04-2006, 06:36 PM
justinmanus justinmanus is offline
Member
 
Join Date: Oct 2006
Posts: 4
Default 200 XC250 still wont start

Ok guys put the new coil on disconnected the kill switch and it still wont start. put plug in the new spark plug wire and had my friend watch for a spark when I kicked it over and he saw nothing. anymore more ideas. I have beer if someone want to join in the fun? One week to gorden wells the countdown begins will the gas gas be there!!!!
Thanks again for all the help and the jokes this is eating at me so those help
Justin
Reply With Quote
  #10  
Old 12-25-2006, 04:46 AM
asistech's Avatar
asistech asistech is offline
Member
 
Join Date: Jul 2006
Posts: 13
Default What Could Have Gome Wrong?

Just got back from my workshop. and did what GMP (thanks man ....) advised you.
I Press the kill switch a few times and there were spark on the coil wire when i kick start.
Actually i just replace the piston and rings. which worn out after the last race. The engine started just fine. I was very happy cause we were planning to trail ride on 22nd and 23rd.
To my disapointment it just refuse to start the next day.
We spent the next 3 days trying to figure what could have gone wrong.
So I open the website and saw your posting. After reading your problem I went throug GMT's posts and immediately ran straight to the workshop.

So my bike will be fine by tomorrow. And I will definatelly kill the kill switch I guess.

Why dont you try GMT advice again. Hope it will work. Take a look at the kill switch again.It could have jammed.
__________________
76 DT125
78 TS125
90 XL185
05 EC200
Reply With Quote
Reply



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
2005 FSE450 wont start itsagas Enduro Engine 4 stroke (including EFI & Exhaust) 5 05-16-2010 08:38 AM
EC200 kick start lever (2000 model) sireid Enduro Chassis & Body 11 01-24-2010 02:56 AM
02 EC 300 wont start GENO 300 Enduro Engine - 2 stroke 0 09-21-2009 10:02 PM
EC200 wont start Skele Enduro Engine - 2 stroke 25 09-06-2009 10:34 AM
wont start clerky clerk Enduro Engine - 2 stroke 8 11-01-2008 01:18 PM




All times are GMT -5. The time now is 09:43 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org