|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Wild hp 300 Motor Rebuild
Ok so i have finally killed my motor and now that its due for a full rebuild what should i be doing,
It used to be a counter balanced motor but that was removed after a small incident destroying the drive gear on it, so do i get a new one or do i get it balanced ? For the new rod i found an X something rod kit on ebay for the Cr250, so that is on the list, i have already got the new wiseco piston, i found some bearings on ebay to replace the mains but do i go sealed or open ? i have to replace the clutch drive plate as i snapped a spring mount off last time , So in your opinion what else should i be doing ? Cheers in advance. Bill |
#2
|
|||
|
|||
Another fellow on here just had his crank, rod and piston balanced; and reported good results. It would be worth checking into, i would. You might have rb-designs set the squish while your at it, and maybe his carb mod too.
Just some ideas. Im by no means an expert. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
wild HP 300 rebuild | case-racing | Other GasGas Bikes/Quads | 16 | 05-25-2011 02:52 PM |
300 Hp Wild Engine Rebuild!?!? | GASGAS300HP | Enduro Engine - 2 stroke | 2 | 03-16-2009 12:08 PM |
Rebuild 200 Motor | ramcclure200 | Enduro Engine - 2 stroke | 0 | 05-04-2007 07:10 AM |