|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
lighting/horn question
Let me preface this by saying I'm a total nOOb when it comes to anything electrical.
I'm trying to put lights and a horn on my '08 ec300 so I can connect trails. I bought the bike used with no headlight, but it did have a connector for one. That connector was the only wiring in the front of the bike other than a handlebar kill switch and a stealth toggle kill switch. I bought a Sicass headlight/horn switch, but there is no connector for it to plug into. Also, the instructions for the horn say to mount it by the coil, but I don't see any kind of connectors that the horn would plug into. I don't see a GG stamp on the horn, but it is stamped made in Spain and I bought it from a dealer. SO, can I use the wiring from the existing headlight connector as power for the Sicass switch, and then run wires from the switch directly to the headlight and horn? All help is appreciated. |
#2
|
|||
|
|||
You should be fine on the headlight. AC in, AC out to LO or HI depending on switch postion. Common terminal on the headlight bulb is grounded. This assumes your set up has a frame ground.
The horn might be tricky. It's likely you will need a rectifier (diode) in series. AC into the horn switch, AC out to the diode to the horn (halfwave). Horn body grounded if it's a single terminal type. If not, ground the second terminal. You could try it first with AC to see if it makes any noise.
__________________
2011 EC250E |
#3
|
|||
|
|||
It worked as I envisioned: old headlight wires into the switch, switch to horn and headlight. I don't need no stinking wiring harness!
Now I have a street legal 2T, and it only added about 3 lbs. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Horn Mounting | kevells | Enduro Electrical & Wiring | 0 | 10-20-2010 01:56 PM |
Lighting Up An 08 | moto9 | Enduro Electrical & Wiring | 4 | 09-24-2010 10:15 PM |
Lighting on a budget | SpeedyManiac | Enduro Electrical & Wiring | 10 | 05-14-2009 05:36 AM |
EC200 horn | sireid | Enduro Electrical & Wiring | 3 | 04-16-2009 02:20 PM |
Tech Article : Headlight & Horn Install | webmaster | Enduro Electrical & Wiring | 0 | 07-20-2006 12:48 PM |