|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
torque
hey guys anyone know the torque needed for an impeller/ clutch basket/clutch springs on my 2000 ec 250?
|
#2
|
|||
|
|||
oh and my txt 1999 250 rear axel torque?
|
#3
|
||||
|
||||
Clutch boss- 40 NM
Springs- 10 NM Impeller- 6 NM Manual has no specific for the axle, but there is a general note that says "Nut, 22mm 130 NM 94 ft.lb" in the front of the manual for a 2006 EC. |
#4
|
|||
|
|||
Thanks very much! That seems pretty high for an aluminium axle and nuts on a trials bike.. I read some were earlier it was between 40 - 50?? Seem about right??
|
#5
|
||||
|
||||
crazy.
On my TXT I just use a foot long spanner until it feels about right. Only 12hp trying to pull it out of line. |
#6
|
||||
|
||||
Didn't know that the axle was ally, sorry. That is why I made sure to say that it was for a 2006 EC model. I'm not familiar with trials bikes, which has been shown in the last two sentences. But now I know twice as much as I ever did about them. I'll stop typing now.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Torque Wrench | boyscout | General Discussions & Announcements | 4 | 09-29-2011 02:43 AM |
Sprocket torque | Rabbitist | Enduro Chassis & Body | 3 | 06-22-2011 10:05 AM |
torque specs | kstreet | Enduro Engine - 2 stroke | 1 | 01-28-2011 07:05 PM |
Torque Value-DISREGARD found it :) | husley | General Discussions & Announcements | 0 | 01-18-2011 01:34 PM |
Torque Specs | steve | Enduro Engine - 2 stroke | 8 | 02-26-2008 09:30 PM |