|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2011 Txt Pro 250 Clutch Bolts
How do I remove the star bolts? 8mm socket is too big and 7mm is too small
Is there a special tool? Also how do you remove the basket? I've taken the breather bolt out but it still feels locked into place Thanks |
#2
|
||||
|
||||
Are you using a 7mm double hex socket? They look identical to the ones I just removed with that. And yes it is the small 5mm hollow Allen key in the centre of the clutch to remove it. It may just need some gentle leverage.
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
#3
|
|||
|
|||
that looks like a job for vice grips and a trip to the bolt shop
__________________
2003 txt250 Pro 2013 Ossa 280i |
#4
|
||||
|
||||
Quote:
I got by with a 7mm ring spanner, they are only done up to something small like 6/7nm
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
#5
|
|||
|
|||
Well good news is the 7mm ring spanner worked on all but one.
Bad news is one was already partially rounded and the ring spanner is not gripping. Any ideas? Thanks |
#6
|
|||
|
|||
Hacksaw or dremel a screw driver slot in it, then get a replacement bolt.
__________________
2011 EC250E |
#7
|
||||
|
||||
And do the bolts up around it to take some load off it. It will come out easier.
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
clutch/brake bolts | 2smokin | Enduro Chassis & Body | 0 | 09-19-2019 07:51 AM |
Clutch cover bolts on 2011 bikes | GasGas | General Discussions & Announcements | 4 | 05-02-2011 08:20 PM |
Removing stock handguards & lever bolts 2011 | epirtle | Enduro Chassis & Body | 0 | 02-26-2011 12:57 PM |
Clutch / Brake Banjo Bolts | iancp5 | Enduro Chassis & Body | 2 | 11-24-2009 04:14 AM |