|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
Put it back how it was and leave it alone.
|
#12
|
||||
|
||||
You nailed it. It was probably 50 degrees out of time. Runs great now the head cleared up the bottom end power and it's stronger in the midrange as well - very happy with the RK head.
|
#13
|
||||
|
||||
Sweet! Gotta love a easy fix. Not much can stop a Gasser from running. 💪
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
#14
|
||||
|
||||
Quote:
I suspect I should take the time to remove mine and reassemble with Loctite. |
#15
|
||||
|
||||
Don't put Loctite on the taper mind. The nut sure as I think you meant. .
On older bikes I relap the taper with a small amount of valve lapping paste (stuff knows why I have any, I've had it since the 80s before I was enlightened). And carefully clean any traces from the keyway.
__________________
'07 EC300 GG '14 TXT250 GG '? 496 CPI Cheetah RZ/RGV hybrid '22 765 Street Triple RS '21 XTrainer '69 Stinger T125 Suzuki '23 TRS 250RR (it's a Trials thing) |
#16
|
||||
|
||||
Very good chance of it matey! Yep get right on it bud, do the wet mod while you are in there. Stop being a lazy bugger!
__________________
Back on a gassy! 2018 EC300! 🤘 Txt 280 07 to make me feel like a gumby again |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2017 ec250 to a 300 cylinder and head swap wit terrible rattling noise | mvrider2 | Enduro Engine - 2 stroke | 2 | 03-02-2020 09:05 AM |
I put my first mile on my yz250f 300 gasgas swap bike!!! | Kbowen4 | Enduro Chassis & Body | 20 | 03-10-2017 08:50 AM |
Seal head swap? Ohlins rear shock | Gass | Enduro Suspension | 4 | 08-17-2016 02:32 AM |
Three Year Head Start -- Parting out in 2018 | AZRickD | Parts | 2 | 07-10-2015 09:49 AM |