|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
Quote:
I'm quite certain it is important that you remove material from the correct side of the gap, as this gap controls the ignition timing (if I'm not mistaken).
__________________
Anders "So you know, that you're over the hill when your mind makes a promise that your body can't fill" (Little Feat: Old Folks Boogie) 2015 EC200 Racing: TE bars, Rekluse Core Exp 3.0, 38mm Lectron & Ohlins S3 steering damper 2006 EC200: 2011 plastics, Rekluse Z-Start, revalved KYB forks & Scotts steering damper 1998 Bimota Supermono 1986 Duc Mille S2 1975 Guzzi sidecar hack 1961 Morini Corsaro 125 etc |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2k3 timing | PEB | Enduro Electrical & Wiring | 2 | 06-26-2016 01:48 PM |
Cam timing 450 FSE | Just James | Enduro Engine 4 stroke (including EFI & Exhaust) | 6 | 07-18-2013 11:14 AM |
PV timing? | Fred1956 | Enduro Engine - 2 stroke | 3 | 04-14-2011 11:40 AM |
Timing a 450? | iancp5 | Enduro Engine 4 stroke (including EFI & Exhaust) | 4 | 05-28-2010 10:17 AM |
For all who know Timing?? | nwcycle | General Discussions & Announcements | 0 | 03-21-2009 11:25 AM |