|
Riding Techniques & Training Increase Riding Skill, Physical and Mental Training, Weight Loss. |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
Missing 2 mins per lap but front is at grip limit!
Finished a race on Sunday - a lot of flat grass and mud corners I would say corner speed plus entry and exit speeds will determine 95% of your overall time.
I had a decent front tyre on - used quite a bit for over a year but not severely worn and my corner speed is limited by its grip - I know i'm pushing it as I had ~30 little front end slides when cornering but I don't loose any time and didn't crash because of the slides so I feel I cannot go faster in the corners. Braking I'd say I'm up there with the best I brake very hard very late - I overtook 10's of people on the brakes and never got overtook there. Accelerating out of corners I can make a bit of time there when the going is grippy but my top speed is also good so only the acceleration out of the corner which is limited by fitness really. The top riders (at this local event) are lapping in 11 min and me 13 min so they are a lot faster.. And they are faster round the corners. I can run a new front tyre next time but doubt it's worth 2 minutes - so how are they cornering faster than me? FWIW rear end grip was good - no issues there loosing the rear particularly and had a new tyre on the rear. I also run tubliss and had 6 front 5 rear PSI so that should help grip quite a bit as well. Thoughts?
__________________
'05 Gas Gas 300 '97 Aprilia Pegaso 650 '99 KTM 200 '95 ish XR630 (died many times in Oz) |
#2
|
||||
|
||||
Can you drop any total weight of the rider and bike?
Have you tried to drop the forks in the triple clamps (to lower the front end) to get more grip? |
#3
|
||||
|
||||
The only time I dropped the forks the front sort of tucked when riding uphill corners stood up so I put it back and have no more handling problems.
I think I need to try a new cornering style wider line and aggressive with the throttle after watching some YouTube clips which are quite good. I can also try to focus on getting my weight further forward to stop the front sliding. Its a shame there were no photos from the last event to see what the difference in posture is between me and the faster guys.
__________________
'05 Gas Gas 300 '97 Aprilia Pegaso 650 '99 KTM 200 '95 ish XR630 (died many times in Oz) |
#4
|
||||
|
||||
Quote:
__________________
06 EC250 |
#5
|
||||
|
||||
Lower than 6 psi that I have already??
Ive been looking at this video quite a bit https://youtu.be/ayvwni_Ex1I I think if I want to get faster I need to change my technique to this which will be quite a big change and a lot to learn. I think I'm riding more like a road bike (rear wheel not spinning not drifting) with MX position (sitting on tank, leg out)
__________________
'05 Gas Gas 300 '97 Aprilia Pegaso 650 '99 KTM 200 '95 ish XR630 (died many times in Oz) |
#6
|
||||
|
||||
Quote:
__________________
06 EC250 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Grip heaters on 2K-2 | thejackrabbit | Enduro Electrical & Wiring | 4 | 01-19-2014 07:50 AM |
Vapour Engine Temp and RPM Limit values? | Hicksi | Enduro Electrical & Wiring | 1 | 12-20-2012 02:38 PM |
Pistons worn out limit | motohellrider | Enduro Engine - 2 stroke | 9 | 11-20-2011 07:22 PM |
Stupid Question? Rev Limit? | Jakobi | Enduro Intake/Carburetion - 2 stroke | 5 | 11-13-2010 05:36 AM |
300 EC RPM limit? | Hollywood | Enduro Engine - 2 stroke | 9 | 09-10-2008 07:59 AM |