|
"Wanted to Buy" & "Want To Trade" Bikes or Parts |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
I think the splines on the shaft are fine upon further inspection, so I tried lightly filing the leading edge of the splines on the kickstarter. It slipped on maybe a few mm further, barely started on the actual splines (as there is a recess on the inside of the yz kickers before the splines start). So, I reckon I will have to file the shit out of the the brand new kickstarter's splines to get it to slide on. The old GasGas one looks worn out and slips on with no real effort. PITA
Sent from my 0PAJ5 using Tapatalk |
#12
|
|||
|
|||
I'm waiting for used first gen. 250f kick to fly in.
It should then look like this. If new type kick from 2012 and on bikes is applicable to your bike, then you might have worn spline issues, as all this stuff is interchangeable. On the other hand, my original kick boss had excessive play in the splines, which I eliminated fully with green loctite. Maybe there is loctite residue on your splines.
__________________
EC 300 2008 EC 300 2018 GP tenere 700 |
#13
|
|||
|
|||
You are right 5valve. The spines appear fine, but when you run your finger down them you can feel a slight amount of marring from running the old worn out kicker for so long. I ended up globbing on the anti seize and jamming it on there. I tested the removal with a prybar on the swingarm pivot as a fulcrum and it comes off fine. If anything, it's extra trail safe. I dig the new addition to my bike.
Sent from my 0PAJ5 using Tapatalk |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
12' 300 kickstarter | adv rider | "Wanted to Buy" & "Want To Trade" | 0 | 02-03-2015 12:28 AM |
12 EC 300 Kickstarter | Wimpy525 | Enduro Engine - 2 stroke | 0 | 04-07-2012 07:15 AM |
kickstarter | mikevancapel | Enduro Engine - 2 stroke | 10 | 12-31-2009 07:04 AM |
Kickstarter | Triple W | Enduro Engine - 2 stroke | 1 | 07-31-2008 05:01 PM |
kickstarter | crazjarhead | Enduro Engine - 2 stroke | 6 | 08-13-2006 07:51 PM |