|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Expansion Chamber Rubbing / Melting Coolant Hose
Hi All, quick question, my expansion chamber is rubbing on / melting my coolant hose on the right side. It's been like this since I've had it, so I'm not sure if something is installed arse-backwards or not? 2011 EC250
I'm planning to sleeve it with a split piece of hose to protect it, but any ideas? Cheers. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Expansion chamber | Jat | Enduro Engine - 2 stroke | 11 | 05-08-2020 04:36 AM |
Ec300 expansion chamber | Trigga | Enduro Engine - 2 stroke | 1 | 05-06-2015 01:04 PM |
'12 300 expansion chamber. | nato | General Discussions & Announcements | 4 | 08-10-2013 06:14 AM |
Expansion Chamber Springs | ddab | Enduro Engine - 2 stroke | 3 | 06-06-2013 12:02 PM |
Expansion chamber x-over | Harry | Enduro Engine - 2 stroke | 2 | 04-15-2011 10:47 AM |