|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
LTR Radiator brace
I brought a set of braces from go fasters and the brace seems about 10mm to long. My radiator seems a bit bent in places, but not too bad. should I bend the rad/tabs to fit, or cut down the brace/post.
Bike is a 02 ec200 Thanks |
#2
|
||||
|
||||
If the brace is fully threaded in to the tab on the frame and the other end sticks out past the grommet in the rad more than a couple mm the rad is bent. It doesn't matter though, as the shroud now mounts to the brace not the rad.
|
#3
|
|||
|
|||
Quote:
Thanks |
#4
|
|||
|
|||
LTR radiator brace
I suggest you put some anti-sieze on the threads, don't ask me how I know.
Trailrider |
#5
|
|||
|
|||
now there is some good advice, lol
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
What Knee Brace ?? | Gas Stu | Injury & Recovery | 19 | 01-21-2010 04:54 PM |
Neck Brace input | PEB | General Discussions & Announcements | 21 | 02-10-2009 09:16 AM |
Leatt Brace | SpeedyManiac | Enduro Product Reviews | 7 | 08-03-2008 08:04 PM |
How to brace rad guards? | d2w | Enduro Chassis & Body | 9 | 01-09-2008 05:19 PM |