NEW recluse clutch ?

ACR Tom · #1 02-22-2013, 08:19 PM

I just installed the recluse I got from Matto Cycle on my 05 200 and is there anything I should do for longevity n preformance ?

desertgasser300 · #2 02-22-2013, 08:59 PM

Just make sure it's adjusted properly. Gas n' go and change oil like you normally would. My rekluse likes shell rotella 15w40.

ACR Tom · #3 02-23-2013, 07:03 AM

OK I read someware I should pull in the clutch if it was sitting for a long time ?

desertgasser300 · #4 02-23-2013, 08:34 AM

Never read that myself, but I still use the clutch in corners, braking and such so it gets pulled in quite frequently. You will probably find yourself pulling in the clutch out of habit most of the time. I wouldn't worry about it to much.

hamilton · #5 02-23-2013, 12:38 PM

I don't think it is designed to be at a stop and left in gear for long periods, check with rekluse before you smoke your clutch plates.

ACR Tom · #6 02-23-2013, 01:45 PM

I am going to try it Sunday as long as it is not a cold rain . Ilike snow so much more than cold rain . Really looking forward to it.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to fix MOST clutch problems + cr250r clutch conversion.	stainlesscycle	Enduro Engine - 2 stroke	70	10-26-2020 04:06 AM
I wonder about the $400 Recluse exp for Honda working in a Gasser?	tnttimber	Enduro Engine - 2 stroke	7	07-15-2012 09:36 AM
Clutch lever doesnt release clutch as soon as motor starts	cal_tony	Enduro Engine 4 stroke (including EFI & Exhaust)	5	05-19-2012 08:59 AM