What did you do to your Gas Gas today?

[rodent]

Originally Posted by Gez

Installed a Strike seats gripper seat cover. Good quality and far grippier than the stocker. I'm quietly confident we will be able to ride down here next weekend.

I'm sure Dictator Dan will fuck that for you.....and me

[reidy]

Originally Posted by Gez

How'd you do the silencer? More Info please

Open up the silencer as if you were changing the packing. Remove the tip from the canister by drilling out the 4 rivets that hold it on. Mark and cut 100mm off the outer canister at the tip end then mark and cut 100mm off the inner core from the tip end. Then measure up and mark where the 4 holes should go, drill the holes and reassemble the new short silencer.

Is that what your after?

[Gez]

Originally Posted by reidy

Open up the silencer as if you were changing the packing. Remove the tip from the canister by drilling out the 4 rivets that hold it on. Mark and cut 100mm off the outer canister at the tip end then mark and cut 100mm off the inner core from the tip end. Then measure up and mark where the 4 holes should go, drill the holes and reassemble the new short silencer.

Is that what your after?

Perfect, thanks reidy

[farmerj]

Originally Posted by Gez

Installed a Strike seats gripper seat cover. Good quality and far grippier than the stocker. I'm quietly confident we will be able to ride down here next weekend.

Gez,

Where did you get those swingarm protectors? I'm interested in using them, although I've heard that they can hold mud & water in there and cause corrosion/discoloring. Do you find that to be a problem?

Jeff

[Gez]

They're polisport protectors. Haven't popped them off yet. I'd say there's mud caught behind there

[rodent]

Not to my bike, but I just sent an email to Vic Roads asking for a refund or an extension of my registration because I couldn't ride my dirtbikes for the last 2 months due to Covid-19........How's that gonna work out for me

[swazi_matt]

Originally Posted by farmerj

Gez,

Where did you get those swingarm protectors? I'm interested in using them, although I've heard that they can hold mud & water in there and cause corrosion/discoloring. Do you find that to be a problem?

Jeff

I used the hyde ones for about 8 years and they are thicker but worse fitting. I just put a good layer of duct tape on the swingarm and when i sold the bike i ripped it off and used spirits to get the glue off and it was all still fine, there were a few spots where the sand had rubbed through the tape, but caught it in time

[Gez]

Originally Posted by rodent

Not to my bike, but I just sent an email to Vic Roads asking for a refund or an extension of my registration because I couldn't ride my dirtbikes for the last 2 months due to Covid-19........How's that gonna work out for me

Haha worth a try, that'd be like a $14 refund?

In other news, I'm heading out on Saturday

[Beastie Boy]

Fitted case saver / slave cylinder protector

20200520_133310.jpg

[Beastie Boy]

Originally Posted by Gez

Installed a Strike seats gripper seat cover. Good quality and far grippier than the stocker. I'm quietly confident we will be able to ride down here next weekend.

What type of handguards you running? Any chance of some close up pics?

I am a looking at options for my EC 300