Stock HEbo Bars 1-1/8 ?

[biggstr6]

I searched the site and seemed to find two different answers on this . On the 08 EC300 Are the stock bars close to pro taper or Magura Bars?

The reason I ask ,I'm looking at getting moose contour bark busters and they couldn't tell which would fit hebo bars ,but theyre site list one for Pro taper,FMF,Tag,& Moose racing flex series CR-HI only.

a Different set for Magura& moose racing flex series except CR-Hi, and another set for Renthal,fatbar,& Nekken.

Anybody know which set would work for the hebo bars?

[RONALD BRUNDIGE]

Get Them For Magura Bars They Fit Way Better Than The Pt Ones.

[REVERUP]

What Ronald said.
Especially after you cut your bar length down. Cause your clamps move inward where the bar is wider. At least that has been my experience.

Roscoe

[biggstr6]

Thanks for the quick reply guys.

[300XCRider]

FYI....

I purchased a set of Pro Taper CRM handguards for the new Gasser. Like always, I cut the stock 31 1/2" bars down to 29". The CRM guards WILL NOT FIT the stock GG bars if you cut them more than say 1/2". With what I cut off, the inside CRM mount needed to be right where the handlebar clamp bolts are. The CRMs are on a truck back to RMMC for a refund. I did find a set of Cycra composite guards at Cycle Gear for 20% off. They will fit. Probably not the strongest solution, but will do until I decide which bars to go with and/or the composites break.