|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
02-08-2015, 06:08 PM
|
||||
|
||||
2015 starter preventative maintenance
I pulled out the starter (three bolts, and disconnect battery first) and pulled the cover of the drive side as the ktms don't have any grease in the bearing in there, which causes annoying failures. The GG starter looks very similar/the same and it has very little grease as well. You need a 5.5mm socket for the long bolts on the starter, the plate above the coil with tabs on it slides off and fits in the recesses in the cover for refitting
Grease it up boys! That's the bearing in there  And that's the end it comes off, be careful not to pull the other end off 
__________________
Oz Current. 2015 ec300r estart, 98 RM 125 2013 Ec300r 2011 Ec300e 2009 Husky TE310 1982 XR500 Honda 1981 KE100 Kawasaki 1978 GT80 Yamaha 
|
|
#5
02-10-2015, 02:05 AM
|
||||
|
||||
|
Quote:
__________________
Oz Current. 2015 ec300r estart, 98 RM 125 2013 Ec300r 2011 Ec300e 2009 Husky TE310 1982 XR500 Honda 1981 KE100 Kawasaki 1978 GT80 Yamaha
|
|
#6
02-10-2015, 09:16 AM
|
|||
|
|||
|
I've just done the same job to a new style KTM starter. They look identical inside and out !
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Website Maintenance & downtime. | webmaster | General Discussions & Announcements | 3 | 03-11-2014 08:32 PM |
| suggested maintenance for 300ec | Orujo | Enduro Other... | 2 | 01-19-2013 05:08 PM |
| Service /Maintenance Intervals | swazi_matt | Enduro Engine - 2 stroke | 5 | 08-07-2012 05:58 PM |
| Valve maintenance 450 engine | speeddemon | Enduro Engine 4 stroke (including EFI & Exhaust) | 5 | 02-17-2010 12:32 AM |
| Maintenance Downtime. | webmaster | General Discussions & Announcements | 0 | 10-07-2009 06:25 PM |
Linear Mode
