|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Can I assemble my PV incorrectly
I recently stripped, cleaned and replaced the bearings on my PV.
When I reassemled it I realised that the two rods were of different lenghts. If I have put the wrong rod in the wrong place will this make a difference to how it operates?? |
#2
|
|||
|
|||
Are they both long enough to reach through the bearings ? I don't remember having to make the decision you're faced with.
It was a long time ago that I had mine apart, but I managed to install the flapper wrong. It sounded funny at idle when I started it. Then, when I twisted the throttle a bit, the piston smacked into the flapper. Everything stopped and coolant was leaking onto the floor. Cleaning the PV got me a new $900 top end. I don't remember how I got it together that way, but don't you do that. LOL I think one of my rods may not have been through the flapper, but above or below it ? A big DOH !!!! |
#3
|
||||
|
||||
Looking at my notes on a nasty, messed up printout of this:
http://www.gasgasrider.org/html/pv_disassembly.html I have noted that the "Control Rod" #29 is the short one, and the "PV Flapper Pivot Rod" #28 is the long one. HTH, Dean
__________________
Thanks to FLY Racing. |
|
|