|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#1
05-04-2007, 08:10 AM
|
||||
|
||||
Rebuild 200 Motor
I am in the process of rebuilding my 200 due to stuffer bolt. I located the manual (thanks Bearman).
In order to get at the crank I need to remove the magnetic flywheel and i'm going to have to split the case halves which according to the manual requires special tools. Does anyone have them or know of another method to remove parts safely?? I have the motor tore down to this point but I don't want to damage any further so if someone could share this information it will be greatly appreciated  Thanks again Ron McClure 
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need help on top end rebuild | rpduc | Enduro Engine - 2 stroke | 17 | 03-27-2009 12:05 AM |
| 05 rebuild | brains | Enduro Suspension | 2 | 07-22-2008 09:54 AM |
| Rebuild | steve | Enduro Engine - 2 stroke | 8 | 01-13-2008 04:06 PM |
Linear Mode
