|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Stripped screw in gas tank
Well it was inevitable that sooner or later I would pull a screw out of the plastic gas tank of 07 250. What do you think is the best way to fix?
|
#2
|
||||
|
||||
1) Get an electric glue gun and fill the hole. Put the screw back in place and tape in place until glue sets up.
2) Buy a "fatter" sheet rock screw (the key is finding a screw that has very coarse threads) and shorten the length with a grinder so it won't go through the tank. If you go to a larger hardware store you should be able to find a lot of varieties of screws to choose from.
__________________
Steve Berkner I've attended 21 Six Days as a working Photojournalist |
#3
|
||||
|
||||
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
seized shroud screw in Clark oversize tank | jostby | General Discussions & Announcements | 6 | 12-13-2009 02:49 PM |
right side PV vent stripped....help | joey11 | Enduro Engine - 2 stroke | 5 | 06-20-2009 02:38 PM |
Stripped bottom of Ohlins | prk03 | Enduro Suspension | 8 | 01-25-2009 09:03 PM |
stripped hex head | nhrider | General Discussions & Announcements | 11 | 05-28-2008 12:06 PM |
Stripped | Brian VT | Enduro Suspension | 4 | 12-09-2007 09:06 PM |