|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Is this power valve lever plate wrong?
This is the power valve lever plate position when I took the right side cover plate off.
The bike is a 2011 250ec. I noticed on other posting that the linkage rod is in the low position at rest (PV closed). Mine is opposite Running bad also.....got a race this weekend so need to fix if wrong. Help |
#2
|
|||
|
|||
Looks like it is stuck open to me.
__________________
Gas Gas EC 300 '06 BMW F650 |
#3
|
||||
|
||||
Take the allen bolt off the bell crank and see if the actuator rod drops down.
If not, the power valve governer is stuck. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
EC125 Power Valve and Oil | oldschool07 | Enduro Engine - 2 stroke | 11 | 09-27-2015 02:34 PM |
Marzocchi 45mm mid valve check plate | stay_upright | Enduro Suspension | 10 | 04-02-2010 12:37 AM |
Power valve | bens25au | Enduro Engine - 2 stroke | 2 | 02-09-2008 11:02 PM |
Sticky power valve?? | moff747 | Enduro Engine - 2 stroke | 9 | 12-22-2007 07:59 AM |