|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Confirm Torque Specs for Forks/Linkage for 2018+ EC300?
Have my owners manual and found what I think is the upper and lower triple clamp torque specs, but would like to confirm before tightening them down. (See attached). Looking at the Upper and Lower flange torque specs.
I like to loosen and retorque my forks after each ride (drop ) to make sure everything is all aligned up correctly - torque the bolts to the correct torque is also important. Also in the manual it says "Link", which I assume is linkage, and all the nuts are at 80nm - This sounds about right, but would like to confirm before bringing down the torque. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2018 Ec300 Jetting Specs | Mud-Ectomy | Enduro Intake/Carburetion - 2 stroke | 53 | 11-17-2021 01:48 PM |
Torque specs :( | NM_GG_Rider | Enduro Chassis & Body | 9 | 07-01-2021 05:35 AM |
2018 EC300 Linkage Slop | emepher | Enduro Suspension | 7 | 07-17-2018 09:01 AM |
torque specs | kstreet | Enduro Engine - 2 stroke | 1 | 01-28-2011 07:05 PM |
Torque Specs | steve | Enduro Engine - 2 stroke | 8 | 02-26-2008 09:30 PM |