|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Where's my Nipple?
I am trying to run my trans vent to the Gas cap vent frame nipple as GMP suggests.(thanks for that by the way) Running a shorty cap vent. Have a 02 xc250. Can anyone tell me where the nipple is?
Thanks Asshat |
#2
|
||||
|
||||
hate to break it to you, but the older bikes didnt have the nipple,they only had one hole up front where your gas tank mounts,the newere bikes had a second hole below yours where the tanks now mounts,my 06 has the hole for it,but I cant use it because of my damper
|
#3
|
||||
|
||||
Sounds like a personal problem.
Can you run it back into the air box? If you can that should be fine.
__________________
2005 YZ 250F |
#4
|
||||
|
||||
On my older bikes I ran it into the airbox. It just fits the nipple on the '07 using the Scotts damper tower.
|
#5
|
|||
|
|||
Thanks all.
Air box it is then. God I love this bike. And I will the next Gas gas I buy, and the one after that. I am Asshat. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Shock Nipple Touches Pipe | PEB | Enduro Engine - 2 stroke | 2 | 10-03-2008 03:02 PM |
Broken nipple! | moff747 | Enduro Engine - 2 stroke | 3 | 03-01-2008 08:16 PM |