|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
EC250 Wiring
I have a 19 EC250 that I used to run with a 24v starter set up.
I'm reverting back to using a single battery but I'm no longer hearing the audible "click" on the starter relay when using the wiring below. Please can I check the wiring as the starter relay and starter motor are new. +ive of battery to one terminal on starter relay Other terminal on starter relay to +ive on starter motor -ive of battery to ground Is that correct? thanks |
#2
|
||||
|
||||
Sounds correct to me. Just make sure if the negative of the battery goes to ground that the starter body is grounded as well.
__________________
WildAzzRacing YouTube channel Trail Riders of Southern AZ club AZ State Parks OHV Ambassador '11 EC250R '98 KDX220 |
#3
|
|||
|
|||
Yes it is. Must be the handlebar switch. What's the easiest way of testing that?
|
#4
|
||||
|
||||
I would just do a continuity test. Take the two wires going to the switch, attach your multimeter to them, and test to see if you have continuity when pushing the button.
__________________
WildAzzRacing YouTube channel Trail Riders of Southern AZ club AZ State Parks OHV Ambassador '11 EC250R '98 KDX220 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2013 Ec250 wiring | Dan | Enduro Electrical & Wiring | 7 | 06-12-2019 12:28 PM |
2005 EC250 Wiring | jcs003 | Enduro Electrical & Wiring | 0 | 01-17-2018 12:32 PM |
2011 EC250 Wiring harness wanted | Motomecc | Parts | 0 | 11-14-2016 04:26 PM |
2002 ec300 light wiring and speedo wiring help needed. | andy176 | Enduro Electrical & Wiring | 0 | 02-04-2014 07:38 AM |
2011 Ec250 wiring questions | toolmaker | General Discussions & Announcements | 0 | 01-04-2011 07:38 AM |