Rieju & GasGas Legacy Riders Club Forum  

Go Back   Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.


Reply
 
Thread Tools Display Modes
  #1  
Old 03-26-2013, 11:52 PM
papa_j papa_j is offline
Senior Member
 
Join Date: Aug 2011
Posts: 124
Default Reed Installation

When re-mounting the reed block is there any sealant I should use? Should I do a leak down test after?

Thanks.


Reply With Quote


  #2  
Old 03-27-2013, 09:30 AM
john r b's Avatar
john r b john r b is offline
Platinum Level Site Supporter
 
Join Date: Aug 2012
Location: Warrenton,Va
Posts: 956
Cool Reed install

Are you using the gaskets? there should be two gaskets. if you dont have the gaskets then I would use sealant. But next time removing the reeds will be more
of a clean up.
Reply With Quote
  #3  
Old 03-27-2013, 10:26 AM
papa_j papa_j is offline
Senior Member
 
Join Date: Aug 2011
Posts: 124
Default

I have the gaskets.
Reply With Quote
  #4  
Old 03-27-2013, 10:46 AM
john r b's Avatar
john r b john r b is offline
Platinum Level Site Supporter
 
Join Date: Aug 2012
Location: Warrenton,Va
Posts: 956
Cool Reed install

I would just use the gaskets only.no sealant.
Reply With Quote
Reply



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Rear Wheel Bearings - Installation Tip MattR Enduro Chassis & Body 34 10-26-2017 02:31 PM
Trailtech Installation and other mods Moto7man General Discussions & Announcements 10 09-06-2012 08:52 PM
Front Axle Installation Process mlyle11 Enduro Suspension 2 05-20-2012 07:55 PM
Swingarm installation order? Trailrider Enduro Chassis & Body 2 06-18-2009 11:08 AM
07 EC300 - steahly flywheel weight installation g dirt Enduro Engine - 2 stroke 3 06-15-2008 05:42 PM




All times are GMT -5. The time now is 06:05 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org