2005 ec250 --> 2011

[RockefellerGG]

The fit of the rear subframe is off. Looks like they did a bit too much welding on it at once or too much on one side first. It isn't square and needs some massaging to fit into the frame.

The Polisport plastics are close, but there are a few areas that needed trimming to fit. Here, I trimmed the fins down to clear the cross-brace.



I also couldn't keep the front of the airbox attached. I drilled the 4 little tabs and put a nut/bolt through. I'll probably add a dab of silicone to these or replace them with a rivet. In this pic, I have just one of the tabs drilled and secured.