|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
2013 EC300 Clutch play
After 18 hours of running the gasser has developed a rather worrying vibration on the over run. I've checked the crank at the timing end and all feels good.
Next on the agenda was the clutch basket; there is a lot of backlash play and play if you rock the basket fore and aft. There was no play along the shaft. The sump plug had a couple of shards of metal but a lot of 'paste' on it, but the oil was due a change (5-6 hours). Is this normal? |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2013 ec300 | Biff | General Discussions & Announcements | 7 | 02-27-2013 12:42 AM |
2013 EC300 temp sensor | skidmarx | Enduro Electrical & Wiring | 9 | 02-24-2013 12:29 AM |
Help with my choice 2011 or 2013 EC300 | rocky2by | General Discussions & Announcements | 13 | 09-13-2012 12:15 PM |
Clutch Adjustment - 3mm of play? | Stef | Enduro Engine - 2 stroke | 1 | 05-22-2010 01:27 PM |