|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Hand guard trouble.
I recently purchased a 2005 ec 250 all stock including the bars, came with enduro enginering hard guards, which worked great until I decided to move the levers into a stand up riding position (down), at that point nothing fit right due to interference with the pressure lines, tried offset mounts, no help. any good ideas?
|
#2
|
||||
|
||||
Get one of these mounts if they fit:
http://www.ktmtwins.com/brp-ktm-upper-handlebar-mount-kit-for-handguards http://www.zeta-racing.com/handguard/mount/index.html I always had trouble with fitment of guards and controls alignment, but in the end i just got used to their up position.
__________________
'14 EC300 |
#3
|
||||
|
||||
I have used the Cycra CRM mounts with good results. Never had trouble routing the wires, hoses and cables.
__________________
Anders "So you know, that you're over the hill when your mind makes a promise that your body can't fill" (Little Feat: Old Folks Boogie) 2015 EC200 Racing: TE bars, Rekluse Core Exp 3.0, 38mm Lectron & Ohlins S3 steering damper 2006 EC200: 2011 plastics, Rekluse Z-Start, revalved KYB forks & Scotts steering damper 1998 Bimota Supermono 1986 Duc Mille S2 1975 Guzzi sidecar hack 1961 Morini Corsaro 125 etc |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cycra hand guard mounting options | thejackrabbit | Enduro Chassis & Body | 14 | 12-16-2013 01:53 PM |
Clutch Trouble | sammyj18 | Enduro Engine - 2 stroke | 10 | 07-24-2009 10:39 PM |
Hand guard issues | jhendr3702 | General Discussions & Announcements | 3 | 09-03-2008 04:10 PM |
Is Gas Gas in trouble in the U.S. | GregM | General Discussions & Announcements | 14 | 12-29-2006 08:55 AM |