|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
just wondering
if my gas gas ec250 engine was to go bang, pistons or whatever?? could i then get it bored out to a 300cc, and roughly how much will it cost,
thanks |
#2
|
||||
|
||||
Do a search on this site.
There are several posts on the subject. I don't think you can bore out the 250 cylinder to a 300. The power valve may hit the piston. |
#3
|
|||
|
|||
http://www.gasgasrider.org/forum/newreply.php?do=newreply&noquote=1&p=26481
ok thanks, will do some searches
|
#4
|
||||
|
||||
I think you can bore it to make a 275 (better confirm though).
|
#5
|
|||
|
|||
To go 300 you will need a new jug
My dealer just quoted almost a grand for jug, piston & gaskets |
|
|