|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Holding back in first and second
I've got an ec300 2011. In first and second gear it holds back and burbles and just won't get going properly, third seams ok and it takes off. I've cleaned the carb and am running NIEG, 178, 38 jets. It starts fine when cold but can take a few kicks when hot. Any ideas would be greatly appreciated.
|
#2
|
|||
|
|||
Lower the needle. Sounds like it's running rich
Sent from my iPad using Tapatalk |
#3
|
|||
|
|||
The needle is on it's lowest setting
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
want to borrow clutch holding tool | savage sausage | United Kingdom | 6 | 06-09-2014 01:42 PM |
Back on the Gas | skid jackson | General Discussions & Announcements | 7 | 07-27-2011 10:33 PM |
Tricks for holding down head o-rings? | motogroove | Enduro Engine - 2 stroke | 10 | 05-14-2011 08:55 AM |
250 vs 300 back to back comparison | firffighter | Ride Reports | 9 | 05-02-2011 09:20 PM |
Two "Don't Miss" Races Back to Back | twowheels | Mid-West Forum | 0 | 09-14-2010 09:11 PM |