|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
And then this became a problem.
my clutch drags. bad. it will start moving the bike with the clutch full in. i was wondering if bleeding the clutch would help this? seems like it would, because if theres any air in the lines, then it wouldnt move the plates apart like its supposed too. i was wondering what you guys thought, as to weather or not it would work.
__________________
03 ec250 hyde skidplate, cycra handguads, protaper contours "what? it seemed like a good idea at the time!" |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
EC 300 problem!!!!!!!! | clerky clerk | Enduro Engine - 2 stroke | 31 | 07-06-2011 05:19 PM |
Downshifting problem | Metalefty | Enduro Engine 4 stroke (including EFI & Exhaust) | 13 | 10-15-2008 05:31 PM |
50 boy problem | Sharpie | Mini Gasser 's Corner | 3 | 09-04-2008 03:58 AM |
07 FSR 450 injector problem? | GavGav | Enduro Engine 4 stroke (including EFI & Exhaust) | 14 | 03-10-2008 05:51 AM |
I think I have a problem | SpeedyManiac | General Discussions & Announcements | 7 | 11-30-2007 11:26 PM |