|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
#17 and 18
In the diagram for the 250-300 does number 18 the o-ring go outside or inside the seal. I assume it rides on the outside of #17 the bushing. Also how is the bushing supposed to be oriented? It has one end with a small taper on the outside edge, should this face the inside or outside of the engine? |
#2
|
||||
|
||||
The o-ring goes on after the seal.
The tapered part of the sleeve faces the seal. The bushing is tapered so you don't cut the seal when you install it. |
#3
|
|||
|
|||
Thank you! Just to be crystal clear the oring goes around the bushing and is held in place by the crank weight gear and nut, correct?
|
#4
|
||||
|
||||
Yes, that is correct.
|
Thread Tools | |
Display Modes | |
|
|