AC and DC Questions

speedy08 · #1 05-07-2011, 12:24 AM

I have an 07 EC250 with the 2k-3 that I am thinking of adding some lighting (headlight, tailight, indicators, horn, etc) to.

My question for you. I noticed on the wiring schematic that there is a white wire coming off of the stator that is not used for anything. Can I leave the ignition as AC (using the current yellow wire coming off of the stator), and then use the white wire coming off of the stator to convert to DC to run lights, as long as I don't ground anything to the frame on the DC side?

I am thinking this would allow me to use separate wiring and not have to tap into the stock wiring.

Would the yellow and white wires need to be separated within the stator for this to work?

Thoughts?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
2k-2/2k-3 Questions	F_G	Enduro Electrical & Wiring	20	09-13-2009 05:31 PM
Top end and pv questions 04 300	nmhinton	Enduro Engine - 2 stroke	3	10-19-2008 08:09 AM
GG FSR 515 Questions....what to do	pbspecial	General Discussions & Announcements	9	04-14-2008 09:11 PM
Ec 200 Questions	rippn450	General Discussions & Announcements	4	11-27-2007 09:52 PM
Questions About The 07's	Boomhauer	General Discussions & Announcements	4	04-07-2007 12:17 PM