![]() |
|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
![]() |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
On my 2006 300 with AS1 I was running an N3CH, top clip with 42/178 jets and it ran pretty good, but still loaded up slightly at low rpm, which made going from woods to hill climb quite difficult. So I thought I'd try an NECH needle, as they are leaner down low. Now I've run it at top clip 178 main and it's lost a little mid range, so I tried 2nd clip, suddenly rich as hell, so I've dropped to a 168 main, the low and and mid range is there, but at 3/4 throttle it's still a bit rich.
I can't find any information on the actual dimensions of this needle, but I'd like to know where I should be going from here. I'm a bit scared of dropping the main jet any more, are there any NExx needles out there that are just a bit leaner on the final taper area?
__________________
2006 EC300 - HPI CDI - 40pilot, N3CH 2nd clip, 178 main. 33.3:1 (30ml:1l) fully-synth, 12:1CR, 1mm squish. 95KG .5kg front 5.7kg rear, re-valved with custom base valve, factory inox spanny, fmf powercore, k&n air filter |
#2
|
|||
|
|||
![]()
A pretty good combo on the 300 is an NEDH clip 3, 42 pilot, 170-175 main depending on region.
I"m actually running your settings on my 18 300 and am about to drop in a 180 main. These new bike like fuel.
__________________
2018 XC300 |
#3
|
|||
|
|||
![]()
How's the squish on the new models? Still a prick / tophat situation?
__________________
2006 EC300 - HPI CDI - 40pilot, N3CH 2nd clip, 178 main. 33.3:1 (30ml:1l) fully-synth, 12:1CR, 1mm squish. 95KG .5kg front 5.7kg rear, re-valved with custom base valve, factory inox spanny, fmf powercore, k&n air filter |
#4
|
|||
|
|||
![]()
Have not had it apart. I'm sure there is room for improvement. The new motor has plenty of power that's for sure.
__________________
2018 XC300 |
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Needles, needles, needles... | Terrence R | Enduro Intake/Carburetion - 2 stroke | 28 | 06-26-2015 06:20 PM |
jet needles | gassergrant | Enduro Intake/Carburetion - 2 stroke | 7 | 09-22-2014 12:55 PM |
needles? | clerky clerk | Enduro Engine - 2 stroke | 23 | 10-13-2008 04:06 PM |
needles | moff747 | Enduro Intake/Carburetion - 2 stroke | 4 | 07-09-2008 04:43 PM |
Needles | skid jackson | Enduro Intake/Carburetion - 2 stroke | 5 | 08-17-2007 06:25 PM |