|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
12' clutch cover on 11' ?
I took the metal clutch cover off my 11' 300 to replace the leaky POS plastic one on my 12' 300.
The plastic 12' cover has a molded nipple that hits the clutch push rod when I tried to fit it up to the 11'. Can I grind off that nipple and still be able to use it back on the 12'? I was going to try to slap it back together for some track time this weekend since the 12' is 3hrs away |
#2
|
||||
|
||||
Quote:
Sent fra min E5603 via Tapatalk
__________________
Anders "So you know, that you're over the hill when your mind makes a promise that your body can't fill" (Little Feat: Old Folks Boogie) 2015 EC200 Racing: TE bars, Rekluse Core Exp 3.0, 38mm Lectron & Ohlins S3 steering damper 2006 EC200: 2011 plastics, Rekluse Z-Start, revalved KYB forks & Scotts steering damper 1998 Bimota Supermono 1986 Duc Mille S2 1975 Guzzi sidecar hack 1961 Morini Corsaro 125 etc |
#3
|
|||
|
|||
Anyone tried the metal 2014 cover on the 2010/11 bikes
__________________
2003 txt250 Pro 2013 Ossa 280i Last edited by swazi_matt; 02-09-2017 at 01:20 AM. |
#4
|
|||
|
|||
I put a '14 or '15 cover on my '13. It fit but I did have to grind the casting in the center down. Haven't had any problems after a season of riding.
__________________
2013 GasGas XC300E 2005 YZ290 1973 Honda CB175 1997 KX60 1983 Yami Tri-Zinger 1984 Suzuki Alt 50 1969 Trail 90 1971 Trail 90 1972 Trail 90 |
#5
|
|||
|
|||
That's a bummer... the casting that directs oil into the centre of the clutch was the reason I bought it and the additional volume
__________________
2003 txt250 Pro 2013 Ossa 280i |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Clutch cover | adv rider | Enduro Engine - 2 stroke | 7 | 07-29-2016 10:33 AM |
Clutch cover ? | biggstr6 | Enduro Engine - 2 stroke | 9 | 03-20-2012 09:58 PM |
RMW Clutch Cover | Rod Overstreet | Enduro Product Reviews | 2 | 01-24-2011 10:51 AM |