|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
powervalve spacer clearance
I have a Christini AWD with 2015 300 engine and E start in it.
I wanted to try the power valve spacer. How wide are they? It looks like it be very close to hitting the starter if it were spaced out more than a half inch or so. Do they fit the newer engines with E start? Thanks. |
#2
|
|||
|
|||
Quote:
Sent from my Moto G (4) using Tapatalk
__________________
2010 GasGas EC300 Nambo |
#3
|
||||
|
||||
You can always bump your ignition timing a few degrees for free. That will give you more bottom end and midrange. Listen for knock just in case but I have not had a problem with this on any of my bikes.
|
#4
|
||||
|
||||
I have the spacer sold from motocrosscenter in my 2015 300 e start and it fits just fine.No problem with the starter at all.
|
#5
|
||||
|
||||
Spiros, the '15 has an adjustable PV Have you adjusted this first before installing the spacer?
__________________
'12 XC 200 TTX Sold '15 XC 250E Sale pending |
#6
|
||||
|
||||
Yes I have adjusted the pv.I have turned the screw from 2 turns out (standard) to 2,5 turns out because I want a more aggressive throttle response (like my 06 300 had )
Apart from that the spacer will benefit you in low revs whatever setting you choose for the pv. |
#7
|
|||
|
|||
So the spacer from checkpoint offroad DOES fit the 2015 300 engine with the e start. BARLEY!!! But it does!
Noticed absolutely no difference in power at all. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Clearance with a smaller silencer | celler | Enduro Engine - 2 stroke | 2 | 03-04-2013 09:36 AM |
Valve Clearance (Tolerance) | Quicky1980 | Enduro Engine 4 stroke (including EFI & Exhaust) | 7 | 02-15-2013 12:44 PM |
Graphics Clearance | Harry | Enduro Chassis & Body | 1 | 11-26-2012 09:29 PM |
powervalve clearance | jeffs2200 | Enduro Engine - 2 stroke | 13 | 08-31-2012 10:44 AM |